If Your condo suite lock is builder's grade and feels flimsy.
Then Upgrade the deadbolt within the building's rules.
Most buildings allow a better lock in the same finish; we check with management first. Deadbolt Installation

Living in a building in Hamilton means two kinds of doors: the suite door you control and the common doors the building manages. We service both, working within house rules on the outer hardware and giving your own door a cylinder, strike and closer that suit how the unit is actually used.
Same fees day or night · Hamilton
Pick the closest, or call (289) 203-6954
Lockout ServicesLocked out of a home or business, a key snapped in the lock or a lock that has seized: entry with the least damage…
Change or Rekey LocksNew keys for the locks you have, or new locks where the hardware has worn out: rekeying, replacement, deadbolts, smart…
High Security LocksCylinders and deadbolts built to resist picking, bumping and drilling, keys that cannot be copied without…
Commercial LocksLocks for shops, offices and buildings: rekeying at turnover, commercial-grade hardware, exit devices, master key…Every key we cut in Hamilton is tested in the lock it belongs to before we leave. It sounds obvious, but a key that works on the bench and sticks in the door is a common complaint about lock work. We turn each one, from both sides where the door allows, and adjust the cut or the cylinder until every key slides in and turns cleanly.
Nearby Ancaster Heights, Clearview Estates, Dancaster Courts, Greenside Acres, Harmony Hall II, Highland Park Survey, Maple Lane, Maple Lane Annex, Maywood, Mineral Springs, Mohawk Meadows, Nakoma, Oakhill, Parkview Heights, Perth Park, Pinecrest, Pleasant Valley and Spring Valley
Getting you back inside, gently.
18 years in business · Let's sort out your door: (289) 203-6954
Hamilton
The lock services offered in Hamilton are grouped the way a door is used. Getting back in when you are locked out. Deciding who holds a working key. Upgrading the hardware so the door resists more than a casual try. Keeping commercial entrances working. Opening and maintaining safes. Each is described below.

Key Fob Programming, Vehicle Lock Repair, Deadbolt Installation, Car Key Replacement, Panic & Exit Hardware…
Tap a situation. The answer opens here.
If Your condo suite lock is builder's grade and feels flimsy.
Then Upgrade the deadbolt within the building's rules.
Most buildings allow a better lock in the same finish; we check with management first. Deadbolt Installation
If You lost the key to your mailbox in the lobby bank.
Then Have the mailbox lock replaced through management.
Lobby mail units belong to the building, so we arrange it with the property manager. Mailbox Lock Replacement
If Someone in the building has a key to your unit.
Then Rekey the suite lock.
The cylinder is re-pinned so only your new keys work; any building access key is preserved. Lock Rekeying
HamiltonOntario
Every square is one home in a hundred.
Try the key while gently pushing, pulling and lifting the door. If it frees up in one position, the bolt is being pinched by the frame and the door is the cause. If nothing changes, look at the key: does it go fully in and refuse to turn, or spin freely? The first points to the cylinder, the second to the tailpiece behind it. Tell the locksmith which you found and the right parts come in the van.
Yes, at every cylinder that was rekeyed. Once the bottom pins are changed, a key cut to the old combination lifts them to the wrong heights and the plug will not turn. The locksmith proves this at each door by trying the old key after the new one, because any door missed from the list would still answer to the old key. That is also why the walk around the property at the start matters: every door meant to be included has to be on the list.
The bolt should extend at least 25 mm into the frame, which is the standard throw for a dwelling's entrance doors and the length most residential deadbolts provide. Part of the bolt stays inside the door for support while the rest sits in the pocket. A hardened steel insert that spins under a saw blade is a common feature worth having on doors that face a street or laneway.
Anchoring leaves small holes at the anchor points, sized to the bolts being used, and on a finished floor these sit under the safe itself where they are never seen again. On tile, the risk of cracking nearby tiles is real enough that an alternative fastening point or a different spot in the room is often chosen instead of drilling straight through the tile itself.
On-site assessment preferred · (289) 203-6954, open 24/7